Instructions for Properly Applying a Vinyl Decal

Thank you for choosing SoKno Kre8tions. Whether this is your first decal or you’re working with a design that’s being a little stubborn, these detailed instructions will help you get a clean, long‑lasting application.

1. Choose Your Location

• Select the spot where you want to place your decal. Make sure the surface is smooth, clean, and non‑porous.

2. Clean the Surface

• Wipe the area with 70% Isopropyl Alcohol and allow it to air‑dry completely.

• (Any residue, oils, or ceramic coatings will prevent proper adhesion.)

3. Prep the Decal

• Before removing the decal from the backing, use a squeegee or credit card to firmly rub across both the front (transfer tape side) and the back.

• This helps the decal stick to the transfer tape for easier application.

4. Remove the Backing

• Slowly peel the transfer tape and decal away from the backing, starting from a corner and pulling down at an angle.

• If any part of the decal stays on the backing:

  Lay the transfer tape back down gently

  Rub firmly over that area a few times

• Begin peeling again while applying steady pressure

5. Position & Apply

• Carefully place the decal onto your cleaned surface. Once positioned, use your squeegee or card to firmly rub across the transfer tape several times.

• This removes air bubbles and helps the decal bond to the surface.

6. Remove the Transfer Tape

• Peel the transfer tape away slowly, again starting at a corner and pulling down at an angle.

• If the decal tries to lift:

  Lay the tape back down, Rub firmly, Peel again with steady pressure

7. Let It Cure

• Once fully applied, do not wash the area for at least 48 hours. This allows the adhesive to fully bond and ensures maximum longevity.

Tip: When removing the decal from the backing it can sometimes help to place the decal front down an a flat surface and begin to remove the backing rather than removing the transfer tape and decal from the front.